If the starter is spinning in the run position, the starter is getting voltage when it should not. I checked the obvious (out of gas, etc.) and changed the fuel pump/filter.
The problem was a short in the ignition wiring when the remote was installed.
Chevy silverado starter keeps cranking. If engine performance symptoms are experienced, they will generally diminish within 1 minute of start up. However, there is a wide range of possible reasons why a chevy silverado 1500 does not start. Go to start it the next day and it starts with the key in the run position, (good thing my foot was on the clutch.) the starter keeps on cranking after it is running.
It ranges from a simple lack of fuel to an empty battery to a broken starter. The truck has an immobilizer but still cranks without the fob in the run position. With 4.8l, 5.3l.gas engine condition:
Our 2003 chevy silverado is cranking slow in the mornings and during the day like a bad battery, but it is a new batery that we had chedcked. Check power to the starter motor solenoid. You may have an injector that is stuck which would cause the starter to break as it fills the cylinder with gas.
This is an important step and is often the cause of a slow cranking complaint. 2004 chevrolet silverado 1500 156,000 mi, visitor. Likes, share, comment and subscribes!!!!follow us on our facebook page.kenkej autoelectrix
Pretty much same as every one else, mine doesnt even crank. The starter voltage drop should be less than.5v drop total on cranking circuit. No, it isn't an ignition issue.
It cranks, but won't start. If this is getting power when cranking, then the issue is with the starter motor solenoid or starter motor. My 2000 chevy silverado 4.8 starter keeps cranking after started but only in park.
There are many problems that can result in a chevy silverado's failure to start, making diagnosing the trouble even more frustrating. ( 296k miles ) i had a pressure reg failure and replaced it. Owners of these vehicles may comment that the engine starter will continue to run after key is released.
2003 5.3 flex long cranking before start i have an 03, flex fuel 5.3. This is a normal condition and no repairs should be attempted.” ha!! You’ll want to take a look at your silverado’s battery cables and battery posts.
The problem you describe could not be a crankshaft sensor because the injectors would not work if it was. Average failure mileage is 27,000 miles. If the starter is spinning and cranking the engine, the starter is probably ok.
Before i sink a boat load of money into this thing at the dealership, any idea? The 1991 chevrolet cavalier has 1 problems reported for starter keeps cranking after engine is started. If you know when it will not immediately start, try spraying carb cleaner or starting fluid in the duct that carries air to the air filter.
The problem you are having sounds the simular with intermittent rendom cranking and starter running with the the engine running. It can burn up, or the wiring associated with it can burn up. A weak coil or bad coil wire, a bad pick up coil or crank sensor or a bad rotor can all cause a change in the spark.
I disconnected the battery to reset system and checked and cleaned all my ground wires from starter and battery hoping to get lucky but still doing it. Make sure your silverado isn’t on fire and have a mechanic take a look. Its been through some puddles lately and.
You should never need i starter shim on a chevrolet. I cut an access hole in. My 2008 silverado won't start battery is charged.
You need to find the reason voltage is getting to the starter at the wrong time. Had the same problem after having a remote start installed in my lx450 about 4 years ago. Occasionally, the fuel pump module will take one or two seconds to build fuel pressure.
If you see smoke, stop cranking! Once the start timer is activated, the pcm/ecm will continue to crank the starter until either the engine starts or a no start time limit is reached. Few things are as annoying as turning the key in your truck and finding it will not start.
I replaced the fuel filter a week ago. We also can be driving down the road and we get the message reduce engine speed and it will not take gas what do you think it can be. I have no idea where to start looking in the electrical system for the issue.
Cranks and will 1/2 catch for a second, but then nothing. Prior to this it would intermitantly start and immediatly stall but start right back up. If a ses light is experienced, dtc p0172 and/or p0175 may be stored.
On rare occasions an extended crank on cold start, brief rough running on cold start, black exhaust color, and/or ses light may be experienced. My question is in reference to my 99 chevy silverado 1500. Defects in the electrical system, the fuel pump or the ignition lock can also paralyze a vehicle.
Check yellow wire leaving ignition switch voltage should stop right after releasing key from start position if not replace ignition swtich.if so access yellow/black wire leaving pcm on pin 39 connector 1.this should stop grounding when key is released.if. Chevy silverado starting problems by paul novak. The 3 times rule goes for cranking the engine, or for just turning the ignition on for a few seconds, off for a few seconds, on for a few seconds.
4 wheel drive image by canakris from fotolia.com. When the ignition switch is held in the start position for 0.4 seconds, the pcm/ecm start timer is activated. My 2000 silverado (105k) doesn't want to start until the third time cranking on cold starts, or even after sitting for 15 minutes or more.
Then the throttle position sensor ( tps ) had to be replaced. Please let us know happens so it. ““ghost start” starter cranks after key is released on cold start chevrolet silverado, suburban, tahoe.
The starter relay doesnt click, fuel pump relay does cycle, all lights go out as if it is going to crank but doesnt. Sometimes the spark is delivered late, weak or not at all.